Bath shower mixer installation guide

If you will be installing new pipes, you will need to do this first, and if you are inexperienced, it is recommended that you consult a professional plumber. If you plan to keep costs and labor down and take advantage of existing plumbing work, you can install a new shower mixer yourself.

Once filled with water, your shower mixer will be quite heavy, so make sure your floors can support this weight in the first step. Check with a professional if you’re unsure as this is important.

Bath shower mixer installation guide

1. The first step is to prepare the shower mixer. You will likely have a support frame that needs to be installed before installing the shower mixer in the bathroom – turning the shower mixer upside down will make this step easier. Make sure you install the structure according to the manufacturer’s instructions and align the legs correctly: when the bathroom shower mixer is in the right position, the legs will adjust to provide good support for the shower mixer despite any uneven floors in the shower bathroom.

Mixers will be tricky to install once the bathroom shower mixer is in place, so you should go ahead with that. A bathroom shower mixer is likely designed to have a built-in drain and drain. The mixers are positioned above a rubber gasket that ensures water-tightness between the mixers and the shower mixer in the bathroom; Then it is fixed from below. Use a small amount of silicone to seal around the overflow and drain. Mixers will be connected to your water pipe using pieces of flexible tubing.

2. At this point, it is necessary to adjust the legs to make small adjustments so that the shower mixer in the bathroom is level. Use a spirit level to check – don’t rely on your naked eye. It is recommended to place your feet on the boards to distribute the weight over the larger bathroom shower stall floor area as the bathroom shower mixer will be very heavy when full of water. Then it’s time to close the edge of the shower mixer. First make sure your bathroom shower mixer and adjacent wall are clean and free of dirt and grease, lubricate the joint with hygienic sealant, then dip your finger in the soapy water and run it over the fresh sealant. This will ensure that the sealant is smooth and that there are no gaps at the edges.

3. The shower hose will come out of your mixer and you will need to install a lift rail on the wall to support the showerhead. The bar allows you to raise and lower the showerhead so that both tall and short family members can comfortably fit in the shower area: make sure the bar is set at a height that will allow it to perform this function correctly.

4. You will also need to attach a shower screen level to the outside edge of your shower mixer to protect your bathroom shower head from shower mist while you shower. Measure carefully to make sure the screen will be flush with the edge of the bathroom shower mixer, preventing water from seeping over the edge onto the floor.


Finally, remember that these are just general tips: you should always follow the specific installation instructions provided by the manufacturer of your shower mixer. That why the best in selling shower mixers that have installation manual.